How do I put my device in recovery mode ?

How do I put my device in recovery mode ?

When nothing is working anymore, you should revert to "recovery mode".  That will install the initial firmware as shipped with the device.

Here are the steps:

  1. Press and hold the main button

  2. Press and release the reset button (you should use a paperclip to push that button through a small hole at the side of the device, next to the SD Card slot)

  3. Wait a few seconds (min. 3)

  4. Release the main button

  5. Start the crowdbeamer with the main button as you normally would


This should put the device into recovery mode